Metal Detector using TDA0161

These metal detectors circuit is using TDA0161 monolithic integrated circuit designed for the detection of a metal body by detecting variations in high frequency eddy current losses. For metal detection requires an external circuit TDA0161 LC tuned.

The output signal is determined by changes in the current bid. Independent of supply voltage, this current is high or low by the presence or absence of a metal object nearby. Metal detector This circuit uses two LED indicators that provide a visual indication of the presence or absence of metals around the coil. To adjust the circuit need to make sure there is no metal near the coil and then set the fine tuning of a "middle ground". After that you need to adjust the course adjustment to turn the LED and adjust the fine tuning to turn off the LED.

Continue Reading of Metal Detector using TDA0161...

Phone Cellular Calling Detector

Phone Cellular Calling Detector

This circuit was advised to ascertain back a alarm is admission in a cellular buzz (even back the calling accent of the accessory is switched-off) by agency of a aflame LED.

The accessory charge be placed a few centimeters from the cellular phone, so its sensor braid L1 can ascertain the acreage emitted by the buzz receiver during an admission call.

The arresting detected by the sensor braid is amplified by transistor Q1 and drives the monostable ascribe pin of IC1. The IC's achievement voltage is angled by C2 & D2 in adjustment to drive the high-efficiency ultra-bright LED at a acceptable peak-voltage.

Notes:

Stand-by accepted cartoon is beneath than 200µA, accordingly a ability on/off about-face is unnecessary. Sensitivity of this ambit depends on the sensor braid type.

L1 can be fabricated by ambagious 130 to 150 turns of 0.2 mm. enameled wire on a 5 cm. bore above (e.g. a can). Remove the braid from the above and wind it with careful tape, appropriately accepting a stand-alone coil.

A bartering 10mH miniature inductor, usually awash in the anatomy of a tiny ellipsoidal artificial box, can be acclimated abundantly but with lower sensitivity.

IC1 charge be a CMos type: alone these accessories can cautiously accomplish at 1.5V accumulation or less. Any Schottky-barrier blazon diode can be acclimated in abode of the 1N5819: the BAT46 blazon is a actual acceptable choice.

Continue Reading of Phone Cellular Calling Detector...